Our piping isometric drawings and layouts are reliable and precise serving the designers and engineers as a prerequisite to conducting stress analysis along with the draftsmen to generate shop fabrication spool drawings. We offer piping drawing services to fabricators, engineers, contractors, MEP firms, consultants helping them with procurement, on-site-construction along with the verification and validation of piping designs. The isometric layouts produced by our team represent all details comprehensively serving as an imperative deliverable of the piping engineering department. Piping isometric drawings are mainly generated from orthographic drawings and serve as a piece of key information to engineers and draftsmen. Orifice meter taps orientation (it depends upon the pipe direction and fluid typeīOM section is a very important section, as it affects the cost of the project.Isometric drawings are extremely advantageous as they exhibit a graphical representation of the 3D piping system designed for the project.Minimum gap requirement between the welds.Field weld and Workshop weld Identification.Structural penetration (if the line is crossing any structure).Control Valve location and arrangement.

Continuation isometric drawing number (if the complete line do not fit in the single sheet).

Dimensions of all components and spools.Slope (if it’s required as per project).Line elevations (it can be centerline or BOP (Bottom of Pipe) elevation).Angle allocation and direction ( clockwise or anti-clockwise).Points to be checked at drawing area are as follows. Design Pressure and Design Temperature (It’s not mandatory).Insulation and Heat Tracing Type (If the line is insulated only).Project Name, Project Code and Area Code.Here, you will learn to check the piping isometric drawing section-wise for ease of learning. The isometric drawing sheet consists of four major parts viz title block, drawing area, BOQ (Bill of Quantity ) section, and Special requirement notes section. To check the connection/end requirements for mounting the instruments. To check special items type and their dimensions To check elevation and orientation of connected nozzle To check line route, dimension, elevation, valve orientation and co-ordinates To check Design Pressure & Temperature, stress critical lines, Hydro test pressure, inspection class and type, etc. To cross-check line number, line size, insulation, special requirement notes (like no pocket, press head), etc. P&ID (Piping and Instrumentation Diagram) Documents Required for Checking Piping Isometric Drawing Documents

Isometric drawing pipe line